Daikin INVERTER FTXM-V Series Engineering Data page 38

FTXM-V Series
01_EN_3P628775-1.fm Page 4 Monday, February 8, 2021 9:14 AM
Indoor Unit Installation Diagram
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the INTELLIGENT EYE sensor. Also keep heating units or humidifiers outside the sensor's
detection area.
A Mounting plate
B Mounting plate fixing
screw M4 × 1" (M4 × 25mm)
Front panel
J Screw cover*
*The 18/24 class models
have 3 screw covers.
Claw
Filter frame
A
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
P SSID sticker with release paper
(attached to the unit)
1-3/16" (30mm) or more
from ceiling
Screw M4 × 5/8" (M4 × 16mm)*
*The 18/24 class models have 5 screws.
Panel
support plate
Appearance of indoor units
may differ from some
Air filter models.
(This is a 09/12 class
illustration)
C Titanium apatite
deodorizing filter (2 pcs.)
Tab Air filter
Titanium apatite
deodorizing filter
How to attach the indoor unit
Hook the hooks of the bottom frame
to the A mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult
to release, remove the front grille.
Front grille
The service lid is removable.
Opening method
1) Remove the service lid
screw.
2) Pull out the service lid
horizontally in the
direction of the arrow.
3) Pull down.
1-15/16" (50mm)
or more from walls
(on both sides)
Caulk pipe hole gap
with putty.
Intelligent eye sensor
D Wireless
remote
controller
F Remote controller
holder fixing screw
M3 × 13/16"
(M3 × 20mm)
36
A Mounting
plate
Hook
Bottom
frame
Mark (rear side)
Service lid
M4 × 1/2"
(M4 × 12mm)
Do not connect
commercially available
drain hose directly to the
indoor unit. (Water leakage
may result)
Cut thermal insulation pipe
to an appropriate length
and wrap it with tape,
making sure that no gap is
left in the insulation pipe's
cut line.
Wrap the insulation pipe
with the finishing tape from
bottom to top.
Before screwing the E
remote controller holder to
the wall, make sure that
control signals are properly
received by indoor unit.
E Remote
controller
holder
EDUS042101
4
3P628775-1