Daikin INVERTER FTXM-V Series Engineering Data page 220

FTXM-V Series
4. Route the harnesses.
When drilling a hole, be careful not to damage the
soundproofing material and other components on
the back side.
For type A Models
1) If there is no hole, drill a ɸ1/8 inch (ɸ3.2mm) hole in the partition plate. (1 location)
2) Fix in place the binding band attached to the
into the hole. (1 location)
3) Install the fan motor base.
• Be careful not to confuse screw types. Refer to "Installation Procedure (2)".
4) Place the drain pan heater harness on top of the fan motor harness, and fix it in place with the
al.
For type B, C, and D Models
1) If there is no hole, drill ɸ1/8 inch (ɸ3.2mm) holes in the partition plate. (3 locations)
2) Fix the drain pan heater harness in place by screwing the
3) Install the fan motor base.
• Be careful not to confuse screw types. Refer to "Installation Procedure (2)".
4) Trim the electrical wiring box with nippers at the locations shown in the figures, then cover the trimmed edges with
the sealing material.
5) Insert the drain pan heater harness into the space that was trimmed, and fix it in place using the
terial.
B
CAUTION
Binding band
If a hole need to be drilled, hold the component
in position to determine the location of the hole.
B
Binding bands
If holes need to be drilled, hold
the component in position to
M4 piercing
determine the locations
screws
of the holes.
drain pan heater harness by screwing the
M4 piercing screws into the holes. (3 locations)
Type C
Trim the electrical wiring box.
Type B
Trim the electrical wiring box.
7
218
M4 piercing screw
sealing materi-
Fan motor harness
Sealing material
D
Drain Pan
A
heater harness
sealing ma-
Sealing materials
D
Sealing materials
D
EDUS042101
IOD-7133