FTXM-V Series
Install the top plate (3) and rear plate (4).
3
5
2.
1
5
3.
5
2.
5
1.
Finished installation of snow hood (suction back)
1
2.
5
2
2
1
1
Arrow A view
5
3.
1.Align the bent surfaces on the left and
right of the rear plate (4) with the
outer surfaces of the side plate (left) (1)
and side plate (right) (2), then tighten
temporarily with 2 screws (5).
2.Install the top plate (3) so that it
covers the rear plate (4) from above,
then tighten temporarily with 6 screws (5).
3.Tighten the top plate (3) and
rear plate (4) temporarily with 2 screws (5)'.
(Refer to Arrow A view)
※The positional relationship between
the side plate (left) (1),
side plate (right) (2),
top plate (3) and rear plate (4)
is as shown in the figure below.
4
3
5
Arrow A view
4.Securely tighten the 10 screws (5) that
were temporarily tightened
in steps 1, 2, and 3.
224
EDUS042101
1
2
3P643417-1