Daikin INVERTER FTXM-V Series Engineering Data page 78

FTXM-V Series
Preparation Before Operation
CAUTION
Incorrect handling of batteries can result in injury from battery leakage, rupturing or heating, or lead to equipment failure.
Please observe the following precautions and use safely.
• If the alkaline solution from the batteries should get in the eyes, do not rub the eyes. Instead, immediately flush the eyes with tap water and
seek the attention of a medical professional.
• Keep batteries out of reach of children. In the event that batteries are swallowed, seek the immediate attention of a medical professional.
• Do not expose batteries to heat or fire. Do not disassemble or modify batteries. The insulation or gas release vent inside the battery may be
damaged, resulting in battery leakage, rupturing, or heating.
• Do not damage or peel off labels on the batteries.
2
3
1
Grip both
sides of the
front cover.
Remote controller
Screws
Remote
controller holder
NOTE
Notes on batteries
• To avoid possible injury or damage from battery leakage or rupturing, remove the batteries when not using the product for long periods of time.
• The standard replacement time is about 1 year. Both batteries should be replaced at the same time. Be sure to replace them with new dry
batteries AAA.LR03 (alkaline).
• When battery power has run out, "battery mark" will begin blinking on the LCD as an alert that the batteries need replacing. In some cases,
when battery consumption is accelerated due to usage conditions, signal reception may decline before the LCD begins blinking.
• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Notes on remote controller
• Do not drop the remote controller. Do not get it wet.
• If dirt becomes an issue, wipe with a soft dry cloth.
01_EN_3P628774-1.indd 10
To insert the batteries
+
1.
Position and
– Slide the front cover to take it off.
correctly!
2.
Insert 2 dry batteries AAA.LR03 (alkaline).
3.
Replace the front cover.
To attach the remote controller holder to a wall
1.
Choose a place where the signals reach the unit.
2.
Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder.
3.
Place the remote controller in the remote controller holder.
Fahrenheit/Celsius display switch
Press
simultaneously for about 5 seconds.
• The temperature will be displayed in Celsius when it is presently displayed in
Fahrenheit, and vice versa.
• The switch operation is only possible when the temperature is being displayed.
• A reception sound will go off for the transmission of set temperature to the indoor unit at
the time of setting the Fahrenheit/Celsius display change function.
and (TIMER button)
76
EDUS042101
Read Before Operation
10
C:3P628774-1
2021/02/10 10:03:40