Daikin INVERTER FTXM-V Series Engineering Data page 116

FTXM-V Series
SYSTEM
INDOOR
UNIT
OUTDOOR
UNIT
NOTE
• A short beep and 2 consecutive beeps indicate non-corresponding codes.
• To cancel the code display, hold
01_EN_3P628774-1.indd 48
„ Fault diagnosis by remote controller
• The remote controller can receive relevant error codes from the indoor unit.
1.
When
" " blinks in the temperature display section.
2.
Press
produced.
• The code indication changes as shown below, and notifies you with a long beep.
CODE
00 NORMAL
UA INDOOR-OUTDOOR UNIT COMBINATION FAULT
U0 REFRIGERANT SHORTAGE
U2 DROP VOLTAGE OR MAIN CIRCUIT OVERVOLTAGE
U4 FAILURE OF TRANSMISSION (BETWEEN INDOOR UNIT AND OUTDOOR UNIT)
A1 INDOOR PCB DEFECTIVENESS
A5 HIGH PRESSURE CONTROL OR FREEZE-UP PROTECTOR
A6 FAN MOTOR FAULT
C4 FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
C9 FAULTY SUCTION AIR TEMPERATURE SENSOR
CC FAULTY HUMIDITY SENSOR
EA COOLING-HEATING SWITCHING ERROR
E1 CIRCUIT BOARD FAULT
E3 HIGH PRESSURE SWITCH (HPS) ACTIVATED
E5 OL (COMPRESSOR OVERLOAD) STARTED
E6 FAULTY COMPRESSOR START UP
E7 DC FAN MOTOR FAULT
E8 OVERCURRENT INPUT
F3 HIGH TEMPERATURE DISCHARGE PIPE CONTROL
F6 HIGH PRESSURE CONTROL (IN COOLING)
F8 OPERATION HALT DUE TO COMPRESSOR INTERNAL TEMPERATURE
H0 SENSOR FAULT
H6 OPERATION HALT DUE TO FAULTY POSITION DETECTION SENSOR
H8 DC CURRENT SENSOR FAULT
H9 FAULTY SUCTION AIR TEMPERATURE SENSOR
J3 FAULTY DISCHARGE PIPE TEMPERATURE SENSOR
J6 FAULTY HEAT EXCHANGER TEMPERATURE SENSOR
J8 FAULTY LIQUID PIPE TEMPERATURE SENSOR
L3 ELECTRICAL PARTS HEAT FAULT
L4 HIGH TEMPERATURE AT INVERTER CIRCUIT HEATSINK
L5 OUTPUT OVERCURRENT
P4 FAULTY INVERTER CIRCUIT HEATSINK TEMPERATURE SENSOR
down for about 5 seconds. The code display also clears if no button is pressed for 1 minute.
is held down for about 5 seconds,
repeatedly until a long beep is
MEANING
114
EDUS042101
When the Need Arises
48
C:3P628774-1
2021/02/10 10:03:56