FTXM-V Series
Install the top plate (3) and front plate (4).
3
3
4
5
Finished installation of snow hood (suction side)
5
2
1
,
5
Arrow A view
1. Align the bent surfaces on the left and
right of the front plate (4) with the
outer surfaces of the side plate (left) (1)
and side plate (right) (2), then tighten
temporarily with 2 screws (5).
2. Install the top plate (3) so that it
covers the front plate (4) from above,
then tighten temporarily with 4 screws (5).
3. Tighten the top plate (3) and
rear plate (4) temporarily with 2 screws (5)'.
(Refer to Arrow A view)
※ The positional relationship between
the side plate (left) (1),
side plate (right) (2),
top plate (3) and front plate (4)
is as shown in the figure below.
4
3
5
Arrow A view
4. Securely tighten the 8 screws (5) that
were temporarily tightened
in steps 1, 2, and 3.
222
EDUS042101
1
2
C:3P643416-1