Kps034A43> Snow Hood (Outlet) - Daikin INVERTER FTXM-V Series Engineering Data

FTXM-V Series
13.20 <KPS034A43> Snow Hood (Outlet)
Component parts
Name
1
Side plate(left)
Shape
Q'ty
CAUTION
● Be sure to follow the contents below as precautions during installation to ensure correct and safe usage.
１． Install at a height and location where maintenance is possible.
２． When installing in a location affected by strong winds, secure the outdoor unit with something such as wire.
３． Avoid installing in locations where the operation sound generated by the outdoor unit affects the neighborhood.
４． Be sure to tighten the screws. Vibration due to screws being loose may result.
Installation of snow hood (outlet)
Install the side plate (right) (2).
１
Before assembling, check that the following parts are available.
2
Side plate(right)
1 pc.
1 pc.
Please read these"Safety Precautions"carefully before performing installation work.
Outlet grill
Front panel of
the outdoor unit
5
2
3
Top plate
1 pc.
１．Take out the 4 outlet grill
installation screws (☆1).
２．After lifting the outlet grill up,
pull the outlet grill toward you to
remove it from the front panel of
the outdoor unit.
※Be careful when removing the outlet
grill as it is installed on
the front panel of the outdoor unit
with claws (6 places).
☆１
３．After removing the outlet grill,
install the side plate (right) (2)
using 2 screws (4) at the top and
bottom locations indicated
by arrows @ in the figure.
４．Install the outlet grill on the
front panel of the outdoor unit
in the order of step 2, then step 1.
※At this time, check that the claws
of the outlet grill are firmly
inserted into the square holes
(6 places marked with @ in the figure)
on the front panel of the outdoor unit.
225
INSTALLATION
4 5
Screw
MANUAL
（M4×12）
1 pc.
11 pc.
(this document)
EDUS042101
C:3P643418-1