Kps034D42> Snow Hood (Intake Rear Plate) - Daikin INVERTER FTXM-V Series Engineering Data

FTXM-V Series
13.19 <KPS034D42> Snow Hood (Intake Rear Plate)
Component parts
Name
1
Side plate(left)
Shape
Q'ty
CAUTION
● Be sure to follow the contents below as precautions during installation to ensure correct and safe usage.
１． Install at a height and location where maintenance is possible.
２． When installing in a location affected by strong winds, secure the outdoor unit with something such as wire.
３． Avoid installing in locations where the operation sound generated by the outdoor unit affects the neighborhood.
４． Be sure to tighten the screws. Vibration due to screws being loose may result.
Installation of snow hood (suction back)
Install the side plate (left) (1).
１
５
Install the side plate (right) (2).
２
Before assembling, check that the following parts are available.
2
Side plate(right)
1 pc.
1 pc.
Please read these"Safety Precautions"carefully before performing installation work.
1
Left side panel of
the outdoor unit
☆１
２
☆２
3 4
Top plate Front plate
1 pc. 1 pc.
１．Install the side plate (left) (1) on
the back of the left side panel of the
outdoor unit using 3 screws (5).
※When used in combination with
an anti-snow hood (suction side)
Place the side plate (left)(1)
on the top side of the
suction side (left) and
1
5
tighten together.
Refer to the figure
on the left.
Suction side (left)
１．Take out screws (☆1 and ☆2)
from the outdoor unit.
２．Install the side plate (right) (2)
with the screws (☆1 and ☆2) taken
out in step 1.
223
EDUS042101
INSTALLATION
5 6
Screw
MANUAL
（M4×12）
1 pc.
13 pc.
(this document)
3P643417-1