Teledyne Everywhereyoulook T3PM1100 User Manual page 7

Power Supply
WARNING
Cleaning the
Instrument
Operation
Environment
(Note) EN 61010-1:2010 specifies the measurement categories and
their requirements as follows. The T3PM1100 falls under category II
600V.
 Measurement category IV is for measurement performed at the
source of low-voltage installation.
 Measurement category III is for measurement performed in the
building installation.
 Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
AC Input voltage: 100-240 VAC 50/60Hz

The power supply voltage should not fluctuate

more than 10%.
Connect the protective grounding conductor of

the AC power cord to an earth ground, to avoid
electrical shock.
Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild

detergent and water. Do not spray any liquid.
Do not use chemicals containing harsh material

such as benzene, toluene, xylene, and acetone.
Location: Indoor, no direct sunlight, dust free,

almost non-conductive pollution (Note below)
Temperature: 0°C to 40°C

Humidity: < 30°C: < 80%RH(non-condensing);

30°C~40°C:<70%RH(non-condensing);
>40°C: <50%RH (non-condensing)
Altitude: <2000m

Overvoltage category: OVC II

SAFETY INSTRUCTIONS
7