5. Slide the switch chassis to the left or right a bit so that the mounting screws are pushed into the
channels of the holes in the mounting brackets until the switch rests firmly in place as shown in
Figure 68 on page
127.
6. Tighten the mounting screws.
Figure 68: Mounting an EX2300 Switch Except the EX2300-24MP and EX2300-48MP Models and the
EX2300-C Switch on a Wall
Mounting an EX2300-C Switch on or Under a Surface Made of Ferrous
Material
Before mounting the switch on or under a surface made of ferrous material:
• Verify that the site meets the requirements described in
Switches" on page
53.
"Site Preparation Checklist for EX2300
127