How To Handle Fiber-Optic Cables - Juniper EX2300 Series Hardware Manual

LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to transceivers
emit laser light that can damage your eyes.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
LASER WARNING: Do not leave a fiber-optic transceiver uncovered except when inserting
or removing a cable. The rubber safety cap keeps the port clean and prevents accidental
exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.

How to Handle Fiber-Optic Cables

Fiber-optic cables connect to optical transceivers that are installed in Juniper Networks devices.
To maintain fiber-optic cables:
• When you unplug a fiber-optic cable from a transceiver, place rubber safety caps over the transceiver
and on the end of the cable.
• Anchor fiber-optic cables to prevent stress on the connectors. When attaching a fiber-optic cable to
a transceiver, be sure to secure the fiber-optic cable so that it does not support its own weight as it
hangs to the floor. Never let a fiber-optic cable hang free from the connector.
• Avoid bending fiber-optic cables beyond their minimum bend radius. Bending fiber-optic cables into
arcs smaller than a few inches in diameter can damage the cables and cause problems that are
difficult to diagnose.
• Frequent plugging and unplugging of fiber-optic cables in and out of optical instruments can damage
the instruments, which are expensive to repair. Attach a short fiber extension to the optical
equipment. Any wear and tear due to frequent plugging and unplugging is then absorbed by the
short fiber extension, which is easier and less expensive to replace than the instruments.
• Keep fiber-optic cable connections clean. Microdeposits of oil and dust in the canal of the transceiver
or cable connector can cause loss of light, reduction in signal power, and possibly intermittent
problems with the optical connection.
228