Indicates The Usb Port For The Switch - Juniper EX2300 Series Hardware Manual

Table 47: Chassis Viewer for EX4300 Switches
Field Description
Console port The Console port (RJ-45) is used to connect the switch to a management console or to a
console server.
USB port

Indicates the USB port for the switch.

NOTE: We recommend that you use USB flash drives purchased from Juniper Networks for
your EX Series switch.
Fan tray Mouse over the fan tray icons to display name, status, and description information.
Power supplies Mouse over the power supply icons to display name, status, and description information.
PIC 1 slot The rear panel of a 24-port and a 48-port EX4300 switch has four (built-in) 40-Gigabit QSFP
+ ports, and the rear panel of an EX4300-32F switch has two (built-in) 40-Gigabit QSFP+
ports, in which you can install QSFP+ transceivers. Mouse over the ports to view the details
of the ports.
After you install a transceiver in the port, the following colors denote the interface status:
•
Green—Interface is up and operational.
•
Yellow—Interface is up but is not operational.
•
Gray—Interface is down and not operational.
For QSFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis
viewer displays
When a QSFP+ port is configured as a Virtual Chassis Port (VCP), the following colors
denote the VCP status:
•
Green—VCP is up and operational.
•
Yellow—VCP is up but is not operational.
•
Gray—VCP is down and not operational.
(Continued)
Transceiver not plugged in
when you mouse over the port.
202