Ex2300 Switch Default Configuration - Juniper EX2300 Series Hardware Manual

EX2300 Switch Default Configuration

Each EX Series switch is programmed with a factory-default configuration that contains the values set
for each configuration parameter when a switch is shipped. The default configuration file for an EX2300
switch configures Ethernet switching and storm control on all interfaces, configures Power over Ethernet
(PoE) on all interfaces of models that provide PoE, and enables the LLDP, LLDP-MED, and RSTP
protocols and IGMP snooping.
When you commit changes to the configuration, a new configuration file is created that becomes the
active configuration. You can always revert to the factory-default configuration—EX2300 switches do
not have LCD panel, use the CLI commands to revert to the factory-default configuration. See
"Reverting to the Default Factory Configuration for the EX Series Switch" on page
NOTE: The factory-default configuration file is different for different EX2300 switch models.
The number of interfaces in the default configuration file depends on the number of ports in the
EX2300 switch.
The poe statement does not appear for models without PoE.
Uplink ports on EX2300 switches except EX2300-C switches are listed as ge-0/1/0 to ge-0/1/3 and
xe-0/1/0 to xe-0/1/3. Uplink ports on EX2300-C switches as ge-0/1/0 to ge-0/1/1 and xe-0/1/0 to
xe-0/1/1.
The following is the factory-default configuration file for an EX2300 switch with 24 ports with PoE
capability that runs Junos OS Release 18.2R3 or later.
system {
auto-snapshot;
phone-home {
server https://redirect.juniper.net;
rfc-compliant;
}
services {
ssh;
netconf {
ssh;
rfc-compliant;
yang-compliant;
}
}
}
179.
156