Ex2300 Power System; Power Supply In Ex2300 Switches - Juniper EX2300 Series Hardware Manual

EX2300 Power System

IN THIS SECTION

Power Supply in EX2300 Switches | 46

Power Specifications for EX2300 Switches | 47
AC Power Cord Specifications for EX2300 Switches | 49
Power Supply in EX2300 Switches
The power supply in EX2300 switches is built in along the rear panel of the chassis, with an AC power
cord inlet or DC power terminals on the rear panel to connect power to the switch.
NOTE: After powering on the switch, wait for at least 60 seconds before powering it off. After
powering off the switch, wait for at least 60 seconds before powering it back on.
Table 14 on page 46 lists the power consumed by each EX2300 switch model.
Table 14: Power Consumed by EX2300 Switches
Model Number
EX2300-C-12T
EX2300-C-12P
EX2300-24T
EX2300-24P
Number of PoE-Enabled Maximum Power
Ports Consumed by the Switch
– 20 W
12 24 W (when no PoE
power is drawn)
– 55 W
24 80 W (when no PoE
power is drawn)
Maximum PoE/PoE+
Power Available
–
124 W
–
370 W
46