Juniper EX2300 Series Hardware Manual page 137

• Place the surface made of ferrous material in its permanent location, allowing adequate clearance for
airflow and maintenance.
General Safety Guidelines and Warnings
• Read
Lifting Guidelines
.
Ensure that you have the following parts and tools available:
• Magnet-mount kit (separately orderable). The kit includes 2 self adhesive rubber pads and 1 magnet
mount sheet.
• At least 2-mm thick flat surface made of ferrous material (not provided)
• (Optional and separately orderable) 1 cable guard kit. The kit includes the cable guard and
3 number-8 Phillips truss-head screws to secure the cable guard to the EX2300-C switch.
• (Optional and separately orderable) 1 standard cable lock kit to secure the switch from theft by
connecting the cable to the security slot on the switch and a desk or a rack to fasten the cable lock.
The kit includes the standard cable lock and its key.
You can mount an EX2300-C switch on or under a surface made of ferrous material by using the
separately orderable magnet-mount kit.
WARNING: Do not mount EX2300-C switches on a ceiling by using the separately
orderable magnet-mount kit.
NOTE: Do not block the vents on the top of EX2300-C switches. Blocking the vents can lead to
overheating of the switch chassis.
To mount the switch on or under a surface made of ferrous material:
1. Remove the switch from the shipping carton (see
2. Turn the chassis upside down.
3. (Optional) Attach the cable guard to protect cable connections:
a. Use the 3 truss-head screws to attach the cable guard to the bottom of the chassis.
, with particular attention to
"Unpacking an EX2300 Switch" on page
Chassis and Component
101).
128