Ex2300 Network Cable And Transceiver Planning; Pluggable Transceivers Supported On Ex2300 Switches - Juniper EX2300 Series Hardware Manual

• If you are mounting an EX2300 switch in a rack or cabinet with other equipment, or if you are placing
it on or under a desk or floor near other equipment, ensure that the exhaust from other equipment
does not blow into the intake vents of the chassis.
NOTE: You can mount only EX2300-C switches under a desk or other level surface.
• Leave at least 24 in. (61 cm) in front of the switch and 6 in. (15.2 cm) behind the switch. For service
personnel to remove and install hardware components, you must leave adequate space at the front
and back of the switch. NEBS GR-63 recommends that you allow at least 30 in. (76.2 cm) in front of
the rack or cabinet and 24 in. (61 cm) behind the rack or cabinet.

EX2300 Network Cable and Transceiver Planning

IN THIS SECTION

Pluggable Transceivers Supported on EX2300 Switches | 75

SFP+ Direct Attach Copper Cables for EX Series Switches | 77
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 79
Calculating the Fiber-Optic Cable Power Budget for EX Series Devices | 81
Calculating the Fiber-Optic Cable Power Margin for EX Series Devices | 81
Pluggable Transceivers Supported on EX2300 Switches
You can find the list of transceivers supported on EX2300 switches except EX2300-24MP and
EX2300-48MP and information about those transceivers at the
EX2300.
You can find the list of transceivers supported on EX2300-24MP and EX2300-48MP switches and
information about those transceivers at the
Hardware Compatibility Tool page for
Hardware Compatibility Tool page for EX2300
75
Multigigabit.