Exb-Di Option - Korg Triton-Rack Parameter Manual

EXB-DI option

The separately sold EXB-DI option provides an ADAT™
Compatible Optical Output which digitally outputs the
audio signal from the TRITON-Rack, and also allows the
digital signal to be synchronized with another digital audio
device.
For an explanation of the DIGITAL OUT connector and
WORD CLOCK IN connector, refer to BG p.8.
In this owner's manual, "ADAT" is used as a general desig-
nation for ADAT compatible multi-track recorders such as
the Alesis ADAT.
Example connections
Digitally recording the sound of the TRITON-Rack to
an ADAT
1 Use an ADAT-Optical cable (sold separately) to connect
the TRITON-Rack's Digital OUT connector to the ADAT's
Digital INPUT.
For connections, use an ADAT-Optical cable manufac-
tured by Alesis Corporation or an optical cable for CD/
DAT (both sold separately).
2 Set the TRITON-Rack's "System Clock GLOBAL 1.1–2a"
to Internal.
3 Set the word clock source of the ADAT to "DIG 48 K."
For details refer to the manual for the connected ADAT.
ADAT
DIGITAL IN
DIGITAL OUT
TRITON-Rack
Digitally recording the sound of the TRITON-Rack
that has been mixed on a digital mixer to the ADAT
1 Use an ADAT-OPTICAL cable to connect the TRITON-
Rack's DIGITAL OUT connector to the ADAT OPTICAL
IN connector of the ADAT Optical format-compatible
mixer.
2 Use ADAT-OPTICAL cables to connect the respective IN
and OUT connectors of the ADAT Optical format-com-
patible mixer and the ADAT.
3 Make connections as shown in the following diagram so
that an Alesis BRC Remote Controller or other ADAT
optical format compatible mixer or remote controller can
be used as the master for digital signal synchronization,
and connect the WORD CLOCK OUT connector of the
mixer to the WORD CLOCK IN connector of the TRI-
TON-Rack.
For connections, use a BNC Coax cable made by Alesis
Corporation or a BNC cable made for video (both sold
separately).
4 Set the TRITON-Rack's "System Clock" to Word Clock.
The digital audio signal that is output from the DIGITAL
OUT connector is output in synchronization with the
clock signal received at the WORD CLOCK IN jack,
allowing the digital signals of the two devices to be syn-
chronized.
If you wish to store the "System Clock" setting, use the
"Write Global Setting" utility to write it.
5 Set the word clock source of the ADAT to "DIG 48 K."
For details refer to the manual for the connected ADAT.
If the clock cannot be detected correctly due to a discon-
nected BNC cable or for some other reason, a error mes-
sage "Word Clock Error!"will appear in the LCD. If this
occurs, check whether a problem has occurred with the
BNC cable.
If "System Clock" has been written as Word Clock, the
same error message will be displayed when the TRI-
TON-Rack is powered-on if the correct clock is not
being input.
CLOCK OUT
Digital Mixer
WORD
CLOCK IN
DIGITAL IN
DIGITAL OUT
WORD CLOCK OUT DIGITAL IN
WORD CLOCK IN DIGITAL OUT
TRITON-Rack
ADAT BRC
WORD
DIGITAL IN DIGITAL OUT
ADAT
273