Korg Triton-Rack Parameter Manual page 120

2.1–1c: UTILITY
"Write Global Setting" (1.1–1d)
Dump Program
Dump Combination
Dump Drum Kit
Dump Arpeggio Pattern
Dump Global Setting
Dump Multi
These commands allow the TRITON-Rack's data to be trans-
mitted to another connected TRITON-Rack, MIDI data filter,
or computer in the form of system exclusive data.
Select the data to be dumped from the Utility menu (see the
table below) to access the dialog box.
As necessary, select the bank and number of the data to be
dumped, and press [F8] ("OK") key.
Dump Program Programs of the specified bank, or one
program
Dump Combination Combinations of the specified bank, or one
combination
Dump Drum Kit All drum kits, or one drum kit
Dump Arpeggio Pattern All arpeggio patterns, or one arpeggio pat-
tern
Dump Global Global settings (except for the Drum Kits
and User Arpeggio Patterns of Global
mode)
Dump Multi All Multi data
Type of data dumped
Program Bank (I–A...I–E, E–A...E–H)
Program Bank (I–F)
Program Single (I–A...I–E, E–A...E–H)
Program Single (I–F)
Combination Bank
Combination Single
Drum Kit All
Drum Kit Single
Arpeggio Pattern All
Arpeggio Pattern Single
Global Setting
Multi Data
Transmission
Do not touch the TRITON-Rack's switches or turn off
the power while data is being transmitted.
Data dump transmission procedure
1 Connect the TRITON-Rack to the device that will receive
the data dump.
If you are using a computer that is able to receive MIDI
exclusive data, connect the computer's MIDI interface
(connected to the computer) to the MIDI OUT connector
of the TRITON-Rack. ( BG p.14)
If you are using a MIDI data filter etc., connect the TRI-
TON-Rack's MIDI OUT connector to the MIDI IN con-
nector of the MIDI data filter.
2 Select Global mode 2.1: MIDI.
3 In the Utility menu, select the data that you wish to
dump.
If you wish to dump data for an individual bank, set
"Program" to Bank, and specify the bank number below
it. If you wish to dump data for an individual program,
set "Program" to Single, and specify the program num-
ber below it.
4 Press the [F8] ("OK") key to transmit the data.
While the data is being transmitted, the display will indi-
cate "Now transmitting data."
The data size and the time required for transmission will
depend on the type of data.
For the size and the time required to dump each type of
data, refer to the table below.
When you save data dumps from the TRITON-Rack to
a MIDI data filer, do not save multiple data dumps
together. If this data is saved together, there will be
insufficient time for the TRITON-Rack to write each
received portion into memory before the next portion of
data arrives, so that it will be impossible to receive all of
the data correctly.
Data size (kByte)
TRITON-Rack EXB-MOSS is installed
69.1 ---
--- 77.3
0.5 ---
--- 0.6
←
57.3
←
0.4
←
592.1
←
4.1
←
105.0
←
0.3
←
0.8
←
9.4–845.4
Time required (Sec)
TRITON-Rack EXB-MOSS is installed
22.1 ---
--- 24.7
0.2 ---
--- 0.2
←
18.4
←
0.2
←
189.5
←
1.3
←
33.6
←
0.1
←
0.3
←
3.0–270.5
113