Korg Triton-Rack Parameter Manual page 255

3–4. Installing the EXB-mLAN.
You must leave the AC/AC power supply disconnected
until you finish the entire process of removing the lid,
installing the option board or memory, and reattaching
the lid.
1 Verify the location where the EXB-mLAN will be
installed. ( the lower diagram in "2. Detaching the lid")
2 Remove the EXB-mLAN from its bag.
3 Remove the three screws holding the (mLAN) cover that
blocks the installation opening of the EXB-mLAN, and
remove the (mLAN) cover. The three screws you
removed will be used to fasten the EXB-mLAN.
The (mLAN) cover you removed will not be used. Take
it out so that it is not left inside the TRITON-Rack.
4 Attach the cable as shown in the diagram. Firmly press
the cable all the way into the connector.
Do not touch any part of the circuit board other than
the connector to which you are connecting the cable.
Connector
248
Lid (for mLAN)
Press all the way in
Cable
Rear panel
5 With the connectors of the EXB-mLAN protruding from
the rear panel of the TRITON-Rack, support the EXB-
mLAN with one hand and use the three screws you
removed to fasten the EXB-mLAN from the rear of the
TRITON-Rack.
EXB-mLAN
6 Reattach the cover by reversing the steps by which you
detached it.
7 After you have completed all the above steps, turn on the
power and verify that the EXB-mLAN has been installed
correctly. ( "Checking after installation")