Dynamic Modulation Source (Dmod); Dynamic Modulation Source List - Korg Triton-Rack Parameter Manual

Dynamic Modulation Source
Specific effect parameters can be controlled while you play
by the TRITON-Rack's REALTIME CONTROLS knobs or by
the joystick or ribbon controller etc. of a connected TRITON
or other MIDI device. Controlling effects in this way is
referred to as Dynamic Modulation. For example, you can
use After Touch to speed up the LFO of the chorus and
flanger, or you can use the ribbon controller to activate the
wah effect. In this way, you will be able to take full advan-
tage of the effects as part of the expressive potential of your
instrument.
Most of the parameters for dynamic modulation consist of
parameter values for "(Source)" and "(Amount)." The
"Source" field selects the modulation source, and
"(Amount)" sets the amount of dynamic modulation effect.
When the modulation source is set to the maximum value,
the actual degree of the effect will be the parameter value
plus the "(Amount)" value.
Example: "W/D (Wet/Dry)" 10:90, "(Source)" AfterT,
"(Amount)" +50
In this case, the effect balance is 10:90. As you apply After
Touch, the percentage of the effect sound will increase.

Dynamic Modulation Source List

Source name
Off
Gate1
G1+Dmp (Gate1+Damper)
Gate2
G2+Dmp (Gate2+Damper)
NoteNo. (Note Number)
Vel (Velocity)
AfterT (After Touch)
JS X (Joy Stick X)
JS+Y#1 (Joy Stick +Y: CC#01)
JS-Y#2 (Joy Stick -Y: CC#02)
Pdl#4 (Foot Pedal: CC#04)
FX1#12 (FX Control1: CC#12)
FX2#13 (FX Control2: CC#13)
Rbn#16 (Ribbon: CC#16)
Sld#18 (Value Slider: CC#18)
Kb1#17 (Knob Mod1: CC#17)
Kb2#19 (Knob Mod2: CC#19)
Kb3#20 (Knob Mod3: CC#20)
Kb4#21 (Knob Mod4: CC#21)
Kb1[+] (Knob Mod1: CC#17 [+])
Kb2[+] (Knob Mod2: CC#19 [+])
Kb3[+] (Knob Mod3: CC#20 [+])
Kb4[+] (Knob Mod4: CC#21 [+])
Dmp#64 (Damper: CC#64)
Prt#65 (Portamento Switch: CC#65)
Sos#66 (Sosutenuto: CC#66)
SW1#80 (SW1 Mod.: CC#80)
SW2#81 (SW2 Mod.: CC#81)
FSW#82 (Foot Switch: CC#82)
CC#83
Tempo
CC#: This is the control change number.
*: This indicates a controller or a function assigned to a controller on the TRITON/TRITONpro/TRITONproX. The controller
and the type of MIDI messages it transmits will depend on the type of connected MIDI instrument.
When After Touch is at its maximum, the effect balance will
(Dmod)
be 60:40.
The dynamic modulation effect will not be affected if
you modify the "Amt" value while dynamic modula-
tion is being applied. The change will become effective
when you operate the dynamic modulation source
again.
Refer to the corresponding effect section for an explanation
of other dynamic modulation parameters.
In the table of parameters for each effect, dynamic modula-
tion parameters are marked by a
of the parameter.
Explanation
dynamic modulation is not used
note on/off
note on + damper on/off
note on/off (retrigger)
note on + damper on/off (retrigger)
note number
Velocity
MIDI channel aftertouch (aftertouch*)
MIDI pitch bend (joystick X= horizontal axis*)
MIDI CC#01: modulation 1 (joystick +Y= vertical axis upward*)
MIDI CC#02: modulation 2 (joystick –Y= vertical axis downward*)
MIDI CC#04: foot controller (assignable foot pedal*)
MIDI CC#12: effect control1
MIDI CC#13: effect control2
MIDI CC#16: controller (ribbon controller*)
MIDI CC#18: controller (value slider*)
realtime control knob 1 in B-mode (knob modulation 1 CC#17)
realtime control knob 2 in B-mode (knob modulation 2 CC#19)
realtime control knob 3 in B-mode (knob modulation 3 CC#20)
realtime control knob 4 in B-mode (knob modulation 4 CC#21)
realtime control knob 1 in B-mode [+]
realtime control knob 2 in B-mode [+]
realtime control knob 3 in B-mode [+]
realtime control knob 4 in B-mode [+]
MIDI CC#64: damper (damper pedal*)
MIDI CC#65: portamento on/off
MIDI CC#66: sostenuto on/off
Assignable switch 1 (SW1 modulation CC#80)
Assignable switch 2 (SW2 modulation CC#81)
MIDI CC#82: foot switch (assignable foot switch*)
MIDI CC#83
tempo (internal clock or external MIDI clock tempo data)
Dynamic Modulation (Example)
Wet / Dry
Wet
60:40
D -mod
10:90
Dry
Zero Higher Max
symbol at the right
Wet / Dry=10:90
Amt= +50
Wet / Dry=60:40
Amt= –50
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
( p.212)
211