Installation And Configuration: Display Sensor; Mounting The Back Plate - Trane Wired Temperature Sensors Installation, Operation And Maintenance Manual

Installation and Configuration: Display Sensor

This section provides step-by-step installation instructions for the display sensor (see applicable
part numbers for the temperature sensor with LCD display on p.
sensor models, see
Read through the pre-installation
Note: Before installing a wired sensor, ensure that a wire access hole is available at the sensor

Mounting the Back Plate

Hazardous voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power cannot be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
NOTICE
Equipment damage!
Applying excessive voltage to the sensor will permanently damage it.
Note: Refer to the illustration below when installing the sensor.
1. Shut off power to the unit controller.
2. Remove the cover by firmly pressing the thumb tab at the bottom of the cover and pulling the
3. Feed the wires through the opening in the back plate.
4. Hold the back plate against the mounting surface and mark the screw locations.
5. Secure the back plate to the mounting surface using the included hardware.
BAS-SVX10C-EN
p. 17.
location and the wire is accessible through the hole. The technician should assume that the
wires are attached to the appropriate unit controller, that there is continuity between the
sensor location and the controller, and that the wires are accurately labeled or identified by
color.
WARNING
cover away from the back plate.
Note: If present, remove the security screw before removing the cover.
information(p. 8) before proceeding with the installation.
p. 6). For installation of all other
Security screw
9