Transport Safeguard For The Rotary Motion - Siemens MOMMOMAT 1000 Installation And Start-Up Instructions Manual

3 - 4
NOTICE
2.

Transport safeguard for the rotary motion

1
Fig. 4 Transport safeguard for the rotary motion
1.
2.
Fig. 5 Transport safeguard mounted on the stand
3.
Mammomat 1000/3000
Installation and Start-Up
The lifting carriage transport safeguard shall be kept for service
purposes (Fig. 5).
Cut and remove the cable tie securing the balancing spring during transport.
Remove the transport safeguard screw (1/Fig. 4) with spacer to enable rotary
motion.
The screw and the spacer should be kept for the mounting of the lifting carriage
transport safeguard.
Mount the red lifting carriage transport safeguard with screw and spacer
(1/Fig. 4) on the left hand side of the stand, see Fig. 5. Insert the screw through the
slot from the inside of the stand, see Fig. 6
Tighten the screw. Make sure that the transport safeguard is parallell to the
stand.
Register 03
Fig. 6 Screw and spacer inserted from the inside of the
stand
SP B7-230.033.07
Rev. 03 11.99
Preparatory work
Page 4 of 8 Siemens-Elema AB
SPS-UD
3
Solna, Sweden