The update kit (Part No. 64 21 528) contains the following parts: Position Quantity Description Lever, assembled Spring Locking pin Locking ring Holder Screw Repair Instructions (this document) Siemens-Elema AB SPB7-230.091.10 Page 1 of 2 MAMMOMAT 3000 Solna, Sweden Rev. 01 02.00 SPS-UD Service...
Page 6
1 - 2 General This page intentionally left blank. MAMMOMAT 3000 SPB7-230.091.10 Page 2 of 2 Siemens-Elema AB Service Rev. 01 02.00 SPS-UD Solna, Sweden...
6.1. Remove cable guide (1/Fig. 1). 6.2. Remove earth screw (2/Fig. 1) and ground cables (3/Fig. 1). Fig. 1 Position of the protective conductors and the cable guide Siemens-Elema AB SPB7-230.091.10 Page 1 of 4 MAMMOMAT 3000 Solna, Sweden Rev. 01 02.00 SPS-UD Service...
Page 8
Position of two of the four screws for the ring Loosen the rotation stop screw (2/Fig. 4). Then turn the object table arm further clockwise to make the two screws accessible. MAMMOMAT 3000 SPB7-230.091.10 Page 2 of 4 Siemens-Elema AB Service Rev.
Page 9
Loosen the screws for the holder (1/Fig. 4) (this screws are later to be replaced by new screws). Fig. 4 Locking lever, view from underneath and a section Remove the old holder. Siemens-Elema AB SPB7-230.091.10 Page 3 of 4 MAMMOMAT 3000 Solna, Sweden Rev. 01 02.00 SPS-UD Service...
Tighten the screws for the holder. Check the operation of the lever for both "flying wing" positions. Fit the bellow. Fit the compression unit. Fit the covers. MAMMOMAT 3000 SPB7-230.091.10 Page 4 of 4 Siemens-Elema AB Service Rev. 01 02.00...