13
WHEELS, TIRES
13.4
Installing the rear wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Remove spacers
M00295-10
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
M00295-11
(FC 250 EU)
–
Position the rear wheel and insert wheel spindle
The brake linings are correctly positioned.
–
Put the chain on.
M00296-10
–
Position chain adjuster
–
Make sure that chain adjusters
–
Check the chain tension. (
–
Tighten nut
Guideline
Nut, rear wheel spindle
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
M00272-11
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
.
p. 95)
. Mount nut
p. 49)
.
Info
The wide adjustment range of the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters
can be turned by 180°.
and contact surface
of the spacers.
.
but do not tighten it yet.
are fitted correctly on adjusting screws
M20x1.5
80 Nm (59 lbf ft)
67
.