Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.4
Cleaning the dust boots of the fork legs
11.5
Removing the fork protector
11.6
Installing the fork protector
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the fork protector. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can accumulate behind the dust boots. If this dirt is
not removed, the oil seals behind can start to leak.
Warning
M00246-10
Danger of accidents Reduced braking efficiency due to oil or grease on
the brake discs.
–
–
Clean and oil the dust boots and inner fork tubes of both fork legs.
Universal oil spray (
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove screws
H00268-10
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
H00268-11
p. 34)
of both fork legs downward.
Always keep the brake discs free of oil and grease, and clean them
with brake cleaner when necessary.
p. 99)
p. 34)
on the left fork leg. Take off the clamp.
on the left fork leg. Take off the left fork protector.
on the right fork leg. Take off the right fork protector.
p. 33)
p. 33)
M6
10 Nm (7.4 lbf ft)
.
M6
10 Nm (7.4 lbf ft)
34
.
.
Advertisement
Table of Contents
