Alcatel-Lucent 1665 Installation Manual page 89

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
Figure 1-18 10/100BaseT cable installation
........................................................................................................................................................................................................................
Route the cables along the backplane and out of the bay to the 110/RJ45 punch down
3
block. Route the cables in the same manner as DS3/EC1 cables. Refer to
"DS3/EC1 and 48TMUX cable routing" (p.
........................................................................................................................................................................................................................
Route the cables along the cable rack and into the terminating bay.
4
........................................................................................................................................................................................................................
Cut cable to length and punch down cable to the 110 block. Refer to
5
"10/100BaseT Ethernet connections" (p. 1-61)
:
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
IN
IN
OUT
OUT
CAUTION
The LNW66, LNW71 and LNW74 10/100BaseT-Ethernet packs do not have
lightning protection for the metallic connections. Therefore it is necessary to
use a lightning-protected patch panel, such as the Black Box CAT5 protected
patch panel JSM110A, for intra-office applications only.
10/100BaseT backplane Ethernet cable installation
IN
1-43).
for pin out assignments.
IN
OUT
OUT
Figure 1-15,
Table 1-11,
1 - 5 9