Alcatel-Lucent 1665 Installation Manual page 175

Software download and circuit pack installation
Result:
OLIU circuit pack. The FAULT, MJ and NE LEDs will light on the SYSCTL due to
DCC alarms created by optically looping the OLIUs. These SYSCTL LEDs will
remain lit until the DCC is disabled. Refer to
connect tests (p. 4-9)
................................................................................................................................................
Starting with slot A1, fully seat the circuit pack slotted there using a steady pressure on
6
both of the faceplate latches at the same time until the circuit pack is fully seated.
Important!
proper cables attached in the back of the shelf.
The ACTIVE and FAULT LEDs should light when circuit packs are inserted and the
FAULT LED should extinguish after a short period of time. Some circuit packs such as
LNW67/LNW68 may take several minutes before their FAULT LEDs extinguish.
................................................................................................................................................
Continue seating the circuit packs with slot A2 and then on to B1, B2, G1, G2, C1, C2,
7
D1, and D2.
................................................................................................................................................
Fully seat Blank packs in any other unfilled slots.
8
Blank Types
LNW177D w/o PEMS
LNW98 w/o PEMS
LNW177D w/ PEMS
*If installing the Fiber
Bracket Kit
LNW98 w/ PEMS
*If installing the Fiber
Bracket Kit
LNW177D w/ Fiber Bracket
Installed
LNW98 w/ Fiber Bracket
Installed
Important!
LNW98 that is equipped with the PEMS.
........................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
After a few minutes the flashing FAULT LEDs should extinguish on each
to clear the alarms.
All electrical circuit packs must be slotted in the function slots with the
Comcode
108950585
109412866
108950585
848949871
109412866
848949871
848960175
848960167
*The Fiber Bracket Kit is used in conjunction with the LNW177D and
Chapter 4, Local equipment and cross-
Series Continue with
S1:2 Step 10
S1:2 Step 10
S1:3 Step 10
NA Step 9
S1:3 Step 10
NA Step 9
S1:3 Step 10
S1:3 Step 10
Circuit pack installation
3 - 7