Lnw66, Lnw71 And Lnw74 (10/100T) Tx Ethernet Cabling Testing - Alcatel-Lucent 1665 Installation Manual

Installation tests

LNW66, LNW71 and LNW74 (10/100T) TX Ethernet cabling testing

............................................................................................................................................................................................................................................................
Description
This procedure is used to test the Ethernet 10/100 TX cabling from the function groups to
the RJ45 patch panel.
Ethernet port assignment verification testing
........................................................................................................................................................................................................................
Connect the Front CIT cable between the PC and the CIT/RS 232 jack of System
1
Controller and login to the shelf using the serial connection.
........................................................................................................................................................................................................................
2 Identify the function groups that contain an LNW66, LNW71 or LNW74 (10/100T)
circuit packs with cabling for testing.
........................................................................................................................................................................................................................
Identify the RJ45 patch panel associated with the function groups identified above.
3
........................................................................................................................................................................................................................
Connect the RJ45 cable from the first RJ45 on the patch panel to the Ethernet port on your
4
PC.
........................................................................................................................................................................................................................
Watch for the link LED to light on the PC's Ethernet card or wait for 30 seconds and then
5
disconnect the RJ45 cable from the patch panel.
........................................................................................................................................................................................................................
The Fault LED will start flashing on the LNW66, LNW71 or LNW74.
6
........................................................................................................................................................................................................................
Verify that there is an inc. FE-LAN LOS alarm associated with the Ethernet port where the
7
signal was removed. Use the Alarm List button on the CIT system view.
........................................................................................................................................................................................................................
Select Configuration -> Update System... -> Update All.
8
Result:
............................................................................................................................................................................................................................................................
4 - 3 6
The flashing fault LED on the LNW66, LNW71 or LNW74 will clear.
LNW66, LNW71 and LNW74 (10/100T) TX Ethernet
cabling testing
365-372-304R7.1
Issue 1, November 2007