Alcatel-Lucent 1665 Installation Manual page 59

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)
........................................................................................................................................................................................................................
Position one of the brackets along the left side of shelf 1. Secure with 3 bracket mounting
8
screws.
........................................................................................................................................................................................................................
Repeat
9
........................................................................................................................................................................................................................
Locate three spools (848919221), one fiber radius control module (321-1B), one right
10
fiber spool bracket (848919221) and 3 M4 X 6 bracket mounting screws (901340059) for
each shelf being installed.
........................................................................................................................................................................................................................
For each spool, put a nylach fastener through the middle. Then insert a pin halfway
11
through.
Important!
deform the fastener and prevent it from being assembled to the bracket.
........................................................................................................................................................................................................................
Line up the nylach fastener in one of the spools with the large holes on the top arm of the
12
bracket.
........................................................................................................................................................................................................................
Spin the spool until the peg on its back fits into the smaller hole on the arm of the bracket.
13
This will keep the spool from spinning any further.
........................................................................................................................................................................................................................
Push the pin until it is completely fastened.
14
........................................................................................................................................................................................................................
Repeat
15
........................................................................................................................................................................................................................
Attach one fiber radius control module to the bottom of each bracket.
16
........................................................................................................................................................................................................................
Position one of the brackets along the right side of shelf 1. Secure with 3 bracket mounting
17
screws.
........................................................................................................................................................................................................................
18 Repeat
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
Step 8 for all the other shelves being installed.
It is very important that the pin is not completely inserted. This will
Step 12 through Step 14
Step 17 for all the other shelves being installed.
for all the spools, with three per bracket.
Fiber management installation (optional)
1 - 2 9