Alcatel-Lucent 1665 Installation Manual page 154

Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
........................................................................................................................................................................................................................
Refer to the engineering job specification. Identify the proper function group(s) and/or
1
growth slot(s) where the low-speed OLIU circuit packs will be installed.
........................................................................................................................................................................................................................
Remove the OLIU from the packing material.
2
........................................................................................................................................................................................................................
Place the circuit pack into the shelf (slot A1, B1, C1, D1 or G1 as required). Do NOT
3
engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
If a companion circuit pack is required, continue with
4
pack into the companion circuit pack slot (A2, B2, C2, D2 or G2 as required), then
proceed to
Important!
flow for cooling.
........................................................................................................................................................................................................................
Remove the second OLIU from the packing material.
5
........................................................................................................................................................................................................................
Place the circuit pack into the shelf (slot A2, B2, C2, D2 or G2 as required). Do NOT
6
engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
Repeat
7
equipped with LNW37, LNW45, LNW49, LNW55 or LNW62 circuit packs.
........................................................................................................................................................................................................................
Install the SFP module per
8
........................................................................................................................................................................................................................
Check off the appropriate box in
9
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
2 - 2 4
Step 7.
Blank circuit packs are required in all unused slots to provide proper air
Step 1 through Step 6
Install pluggable transmission modules (p. 2-34)
S
F T E P S
for each additional function group and/or growth slot to be
Appendix E, "Installation
Initial circuit pack installation
Step 5. If not, install a blank circuit
checklist".
Issue 1, November 2007
365-372-304R7.1