Software download and circuit pack installation
Provision/enable/disable TCP/IP on an IAO LAN port
............................................................................................................................................................................................................................................................
Description
This is an optional task which describes the steps necessary to provision, enable or disable
the TCP/IP on the IAO LAN Port.
Before you begin
Prior to performing this task, you must:
Obtain the work instructions for this task.
•
Know which LAN Port is being provisioned.
•
Obtain the IP Address and IP Subnet Mask of the desired LAN Port and the IP Default
•
Router Address if you are connecting to a router.
Be able to log in to a 1665 DMX with the WaveStar
•
functions of the WaveStar
Procedure
Proceed as follows:
................................................................................................................................................
Use the WaveStar
1
Graphical connection.
................................................................................................................................................
Determine which IAO LAN Port(s) you want to use (front or rear).
2
Important!
using the front IAO LAN port, use lan-1 as the AID.
................................................................................................................................................
From the System View menu, select
3
Administration -> Data Communications
Result:
................................................................................................................................................
In the Data Communications window, click on the TCP/IP tab at the top of the window.
4
Result:
........................................................................................................................................................................
3 - 1 4
®
CIT.
®
CIT to log in to the 1665 DMX shelf being provisioned using a
If you are using the rear IAO LAN port, use lan-2 as the AID. If you are
The Data Communications window opens
The TCP/IP parameters are displayed.
Provision/enable/disable TCP/IP on an IAO LAN port
®
CIT and be familiar with the
365-372-304R7.1
Issue 1, November 2007