Cable And Optical Fiber Installation - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)

Cable and optical fiber installation

............................................................................................................................................................................................................................................................
Introduction
Important!
circuit packs.
........................................................................................................................................................................................................................
If fiber management systems have been installed:
1
a. High-speed fibers should be routed along the fiber radius control module and then
b. Fiber management of low speed fibers should start with the lowest spool. Once
c. As shown in the picture below, fiber from the lowest spool (low speed) is routed in
Important!
Hellerman Tyton RED grip tie (GT.75X1802) or equivalent. The low speed fiber
should be held with Hellerman Tyton YELLOW grip tie (GT.75X1804) or equivalent.
............................................................................................................................................................................................................................................................
1 - 3 2
Ensure only ANGLED LC connectors appear at IN ports of optical
up to the uppermost spool.
full, fiber should be routed along the fiber radius control module and then up to the
middle spool.
the outermost section of the fiber duct; the middle spool (low speed) to the middle
section; and the upper spool (high speed) to the inner section.
The high-speed fiber, routed in the innermost duct, should be held with
Cable and optical fiber installation
365-372-304R7.1
Issue 1, November 2007