Table of Contents
Advertisement
T14SG/FX-22/T12K → T16IZ MODEL DATA CONVERSION
The model data (only latest version) of T14SG/FX-22/T12K can be copied to T16IZ.
* SD card is required.
* The model data of T16IZ cannot be copied to T14SG/FX-22/T12K.
[Model data conversion method]
1. Attach an SD card that contains model data
of T14SG/FX-22/T12K to the SD slot of a T16IZ.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in
the card. Select a model data that you want
to convert and push "CONVERT" → "Yes" key,
and the converter should begin converting
data.
4. If the convert succeeds, the converter will
show the following message. The converted
data are copied to the internal memory of
the T16IZ. Hence, if the T16IZ does not have
available space in its internal memory,
converts must fail.
5. The converter can accept model data
made by T14SG/FX-22/T12K with the latest
software only. If you try to convert model
data made by old version software, the
converter must fail to convert and show
the following error message. If this message
is shown, do the following procedure to
update the model data in order to avoid
this limitation.
(a) First, update a T14SG/FX-22/T12K to the latest software.
(b) Load the model data which failed to convert into the
T14SG/FX-22/T12K with the latest software, and the
model data should be updated to the latest format.
(c) Save the updated model data to a SD card.
(d) Retry to convert the updated model data on a T16IZ.
* When SD card cannot be recognized, it may be able to
be used if it reformats by SD formatter offered from SD
Association.
SD formatter is downloadable from SD Association
https://www.sdcard.org/
CAUTION
After finishing data copy, be sure to
perform a complete check of operation
with the model to be used.
Check well all the directions of operation
and all the operation switches.
223
Advertisement
Table of Contents
