Trainer - FUTABA R7108SB Full Manual

Trainer

T16IZ trainer system makes it possible for the
instructor to choose which channels and operation
modes can be used in the student's transmitter.
The function and rate of each channel can be set.
The training method can also be matched to the
student's skill level. Two transmitters must be
connected by an optional Trainer Cord, and the
Instructor's transmitter should be programmed for
trainer operation, as described below.
When the Instructor activates the trainer switch, the
student has control of the aircraft (if MIX/ FUNC/
NORM mode is turned on, the Instructor can make
corrections while the student has control). When
the switch is released the Instructor regains control.
This is very useful if the student gets the aircraft
into an undesirable situation.
● Setting data are stored to model data.
● Student rate can be adjusted at MIX/FUNC/
NORM mode.
● Activated student channels can be selected
by switches.
Corresponding types of transmitters and trainer mode settings:
Types of transmitters
Instructor
T16IZ,FX-32 T16IZ,FX-32
T14SG,T16SZ, T14SG,T16SZ,
T18SZ,T18MZ, T18SZ,T18MZ,
T32MZ
T14MZ, FX-40, T12Z,
T16IZ
T16IZ T8FG, FX-20
T10C, T9C,
T16IZ
T7C,T6EX, T4EX
T16IZ T10CG,T7C
T10J, T8J, T6K, T6J,
T16IZ
T14MZ, FX-40, T12Z,
T12FG,
FX-30
T8FG, FX-20
T10C, T10CG, T10J,
T9C, T7C
T7C, T8J, T6K
T6J
Trainer system starting and setting
Instructor's transmitter settings
System Type
Student Mod. mode
Arbitrary
T32MZ
T12FG, Arbitrary
FX-30
Arbitrary
Arbitrary
Arbitrary
Arbitrary
T6L
T16IZ Arbitrary
T16IZ Arbitrary
T16IZ Arbitrary
Note: This trainer system can be used in the following
manner:
1. With the T16IZ transmitter and a conventional
transmitter, if the channel order is different, it is
necessary to match the channel order before using this
function.
You can select the channel of input data from student's
transmitter in the "FUNC" or "MIX" mode.
2. When the T16IZ is used as the instructor's transmitter,
set the modulation mode of the student's transmitter to
PPM.
If being used as the student, T16IZ can be connected to
the instructor's transmitter which requires the student's
mode to be PPM. T16IZ always sends PPM mode signal
from the trainer jack.
(In the case of student's transmitters other than 2.4 GHz)
3. Be sure that all channels work correctly in both
transmitters before flying.
Student's transmitter settings
Trainer setting System Type
CH mode Mod. mode
16CH Arbitrary
PCM-G3
12CH
2.4G
12CH FASST-MLT2
8CH FASST-MULT
8CH PPM
8CH Arbitrary
8CH Arbitrary
12CH Arbitrary
12CH Arbitrary
- Arbitrary
113
Trainer setting
CH mode Mod. mode
16CH -
12CH PPM
- -
- -
- -
- -
12CH -
12CH -
8CH -
Trainer Cords
T12FG and 9C
Trainer Cords
T12FG
T12FG
T12FG and 9C
Trainer Cords