S.bus Servo - FUTABA R7108SB Full Manual

S.Bus servo

An S.BUS(2) servo can memorize the channel and
various settings you input. Servo setting can be
performed on the T16IZ screen by wiring the servo
as shown in the figure.
* With some S.BUS(2) servos, there are some functions which
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
* After reading completion, with connection of the above
figure, if a stick is moved, servo operation can be tested.
● Call the following setting screen by pressing the
[S.BUS Servo] button in the System menu.
●Return to System menu
Procedure for changing S.BUS servo
setting
1. Select [S.Bus servo] of the System menu.
2. Wire the servo as shown in the figure above.
3. Press [Read]. The ID and current setting of
that servo are displayed.
● Servo ID number
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
that specific servo.
S.BUS servo setting
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
58
S.BUS/S.BUS2
Servo
3-way hub
or Y-harnesses
S.BUS/S.BUS2
Servo