FUTABA R7108SB Full Manual page 84

Timer
The Timer function may be set for
any desired time, i.e. engine run time,
specified times for competitions, etc.
Two independent timers are provided
for your use. The timers are stored
independently with each model, meaning
that when you switch between model
setups, the timer associated with the new
model is brought up automatically.
The timers may be set to start and stop
from the motion of any switch or stick.
You may set the ON and OFF directions
freely. Each timer has a capacity of up to
59 minutes 59 seconds.
● Select [Timer] at the linkage menu and call the setup
screen shown below.
●Return to
Linkage menu
Elapsed: Minute-by-minute
alarm starting from 00:00
Remainder : Minute-by-
minute alarm counting down
from a designated time
[Inhibit] → [Type1-4]
If it carries out like this,
a vibration function
will work.
Up timer/Down timer selection
1. Tap the mode button and select the type of
timer.
2. Timer time setting.
Tap the Mode minutes or seconds button.
Value input buttons appear on the screen.
Use these buttons to set the timer time.
Timer setting
Each timer may be set for count-down or count up operation
with a target time.
If a target time is set and the timer reaches the set time, a
buzzer sound for each count is generated.
Time ：
OFF: Turning the power OFF and switching models will reset the timer.
ON: Previous timer is put into memory and will restart from where it stopped.
[Start/Stop] → Home screen
A timer on the home screen starts and stops its countdown
directly from there when tapped. Tapping and holding the
display will reset the timer.
Timer 1
Last twenty seconds Last ten seconds
One short
Alarm :
beep
Timer 2
Start/Stop/Reset switch setting
1. Tap the Start/Stop/Reset SW "--" button to
call the <Switch> screen, and then select the
switch and its ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual. The timer switches
can be set for each condition.)
84
Target time
Two short
Continue counting
Also
beeps
with displaying a
beep
minus (-) sign.
A Buzzer or Speech
can be chosen
Constant: The alarm
does not stop
One time: Stop the
alarm at once