Pitch → Needle - FUTABA R7108SB Full Manual

Pitch → Needle
This mixing is used when the engine is equipped
with needle control or other fuel-air mixture
adjustment. A needle curve can be set.
An acceleration function which temporarily
● Select [Pitch→Needle] at the model menu and
call the setup screen shown below.
●Return to Model menu
● Mixing curve setting
*For a description of the
curve setting method,
see the description at
the back of this manual.
Setting method
● When using this function, Tap [INH]. (ON is
displayed.)
● When you want to set the same contents at
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
● A needle curve can be set.
● A switch can be set.
When [--] is set, the mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap
to the [--] item. Tap the screen to call the
selection screen and set the switch and its
ON position.
increases needle operation at throttle stick
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
adjusted.
< Acceleration function setting>
● A c c e l e r a t i o n c a n b e s e t a t b o t h
acceleration (high) and deceleration (low).
●The acceleration rate (rate) and the return
time after operation (damping) can be set.
● A n o p e r a t i o n p o i n t ( A c t p o s i t i o n ) a t
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
167
Normally, use [Point] type.