V-Tail�����������������������������������������������������������������������������������149 Screen - FUTABA R7108SB Full Manual

V-Tail
This function lets you adjust for left and right rudder
angle changes at elevator and rudder operation of a
V-tail airplane.
V-tail is when 2 servos are used together to control
rudder movement as elevators. In addition to each
rudder side moving up and down together, each side
moves in opposite directions when moving as elevators.
On a V-tail, this is also known as a ruddervator, as they
can serve the same purpose.
● Select [V-Tail] at the model menu and call
the setup screen shown below.
●Return to Model menu
Condition group/
single mode
selection (Gr. /Sngl)
(Elevator function)
Up and down travel adjustment at
CH1 and CH2 elevator operation
[Corresponding model type]: Airplane/glider, Tail type V-tail
● Travel adjustment
Tap to the item you want to adjust.
Adjust the rate using the "▼▼" "▼" "▲" "▲▲"
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
ELEVATOR
(RUDDER 2)
(Rudder function)
Left and right travel adjustment at
CH1 and CH2 rudder operation
149
RUDDER
(ELEVATOR 2)