Wired Connection:advanced Setting - FUTABA R7108SB Full Manual

1
1. Select "Gyro setting" on the last page of
Helicopter Model Menu
2
2. Select "Start"
3
3. Home screen is displayed
◆ When copying data from Gyro A to Gyro B
Connect the gyro A to the T16IZ and press [Start]. (Enter the data of A into T16IZ)
If you press Start here, the B data will be written
to the T16IZ and the A data will be lost.
Connect Gyro B to T16IZ and press [GY Settings Transfer]. (Put data on A into gyro B)
SETTING
A. Wired connection: Advanced settings
*If "CRSF" is ON in the system type of the linkage
menu, "Gyro setting" cannot be selected.
When "GY Settings Transfer" is
selected, the gyro setting data saved
in T16IZ is written to the gyro.
Select "Start" This will download
the gyro data to the T16IZ.
To basic menu
To expert menu
To receiver
174
CAUTION
Be sure to connect and disconnect the CGY760R/CGY755 and
T16IZ connection cable with the power off.
* At this time, if Gyro is not connected to T16IZ by wire, the EQ
ID screen appears.