Snap Roll (Airplane Only) - FUTABA R7108SB Full Manual

Digital proportional r/c system
Table of Contents

Advertisement

Snap roll
This function selects the switch and rate adjustment
of each rudder, (ailerons, elevators, or flaps) when
a snap roll is performed.
● Four snap roll directions can be set. (Right/up,
right/down, left/up, left/down)
● Operation mode: When [Master] mode is selected,
the Snap Roll function is turned ON/OFF by master
switch in the state in which the direction switch
was switched to the direction in which you want
to snap roll. When [Single] mode is selected, snap
roll in each direction can be executed by means
of independent switches.
● A safety switch can be set. As a safety measure,
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
when the safety switch is ON.
● The operation speed of the aileron, elevator, and
flap servos can be adjusted for each snap roll
direction. (In side/out side)
● Select [Snap roll] at the model menu
and call the setup screen shown
below.
●Return to Model menu
Master or Single is
chosen
Snap roll
directions
[Corresponding model type]: Airplane, general
Master mode : Direction
switches
Single mode : Snap roll
switches
(Example) Setting example for F3A
● Mode: [Master]
● Safety SW: [SW-G] (Safety measure)
● M a s t e r S W : [ S W - H ] ( M a i n s w i t c h f o r
executing snap roll)
● Direction switches:
*The snap roll up side left and right and down side left and
right direction switches are selected here.
Right/Up: [SW-D] OFF-OFF-ON
Right/Down: [SW-D] ON-OFF-OFF
Left/Up: [SW-A] OFF-OFF-ON
Left/Down: [SW-A] ON-OFF-OFF
● Speed adjustment
The operation speed of each control
surface when the snap switch is ON can
be changed and snap roll executed by
stick while there is switch operation can be
performed.
The ON/OFF switch
of snap roll is chosen.
Aileron, elevator and
Rudder rate adjustment
142
The safety switch is
chosen.
To next page
Condition group/
single mode
selection (Gr. /Sngl)
In speed
Out speed
(First) 0 ~ 27 ( Slowly)
(First) 0 ~ 27 ( Slowly)

Advertisement

Table of Contents
loading

This manual is also suitable for:

T16iz series01000141

Table of Contents