Telemetry:voltage [Battery] - FUTABA R7108SB Full Manual

Telemetry: Voltage [Battery]
In this screen, the battery voltage is displayed. In
order to use this function, it is necessary to connect
External voltage connector of R7108SB ⇔ SBS-
01V ⇔ Battery
SBS-01V measures two batteries. The power
battery connected to two lines is displayed on EXT-
VOLT. The battery for receivers connected to 3P
lines is displayed here.
● Tap the [Voltage] button in the Telemetry screen
to call the setup screen shown below.
●Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alarm set
1. Tap Alarm and choose from Buzzer,
Voice, and Inhibit.
2. Choose "Inhibit" for Vibrator if not using
the vibrator alarm. If using vibrator,
choose one of the three types.
3. Tap to the Limit [4.0 V] item .
4. Adjust the rate using the "▼▼" "▼" "▲"
"▲▲" buttons.
Initial value: 4.0 V
Adjustment range: 0.0 V~100.0 V
*When the screen is tapped for one second, the rate is
reset to the initial value.
5. To terminate the input and return to
the original state, push the HOME/EXIT
button.
*Refer to the manual of SBS-01V for the details of
wiring.
Displaying data from the receiver battery voltage
*SBS-01V must be installed in the aircraft.
In this screen, the battery voltage of a receiver is
displayed.
If it becomes higher or lower than the settin, an
alarm and/or vibration will alert you.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Vibrator choices are
type1-3, and Inhibit.
＜ Two examples of wiring are shown ＞
Two drive batteries are measured (R7108SB use)
Drive battery 1
（EXT Battery)
Drive battery 2
（EXT Battery)
Receiver battery
Two drive batteries and power supplies for servos are measured (R7108SB use)
*SBS-01V measures two voltage. One corresponds to high voltages, such as a drive battery,
with an EXT line. Another is a normal line and is measurement of the battery for receivers of a
line connected to 3P connector, or the battery for servos.
Drive battery 1
（EXT Battery)
EXT Line
Drive battery 2
（EXT Battery)
Power supplies
Switch
for servos
S.BUS2
●Battery voltage measurement for receivers [R7108SB use]
servos
●The drive battery 1 is measured in an EXT port [R7108SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
●The voltage for servos is measured in a power supply line [SBS-01V use]
101
Battery voltage
Sets the voltage on
which the alarm
operates.
to S.BUS2
port
EXT Line Normal Line
R7108SB
●Battery voltage measurement for receivers [R7108SB use]
●The drive battery 1 is measured in an EXT port [R7108SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
to S.BUS2
Normal Line port
Another power
supply Hub
Receiver battery
R7108SB