Linkage Menu - FUTABA R7108SB Full Manual

The Linkage menu is made up of functions which
perform model addition, model type selection, end
point setting, and other model basic settings.
Linkage menu functions table
Servo monitor
Model select
Model type
Servo reverse
End point
Servo speed
Sub-trim
Function
Fail safe
System type
Trim setting
Throttle cut
Idle down
Swash ring
Swash
Stick alarm
Timer
Function name
Sensor
Telemetry
Tele.setting
Trainer
Warning setting
User menu setting
Date reset
● Select the function
name and return to
the Home screen.

LINKAGE MENU

Displays the servo test and operation position
Model addition, call, deletion, copy, model name setting
Model type, wing type, tail type, swash type, selection
Servo direction reversal
Servo basic rate adjustment and limit setting
Servo speed setting
Adjusts the neutral position of each servo
Channel assignment of each function can be changed
Fail safe function and battery fail safe function setting
System mode selection, link of a transmitter and receiver, telemetry mode selection
Control step amount and mode selection of the digital trim
Stops the engine safely and easily
Lowers the idle speed of the engine
Limits the swash plate travel to within a fixed range. (helicopter only)
Swash AFR and linkage correction function (helicopter only except swash type H-1)
Can be set so that an audible alarm sounds when the throttle stick reaches the set position.
Timer setting
Function name can be changed
Various telemetry sensors setting
Displays various data sent from the receiver
Telemetry data log
Starts and sets the trainer system.
Mixing, throttle position warning reset
Original menu making
Model memory set data reset (by item)
● Tap the [Linkage menu] button in the Home
screen to call the setup screen shown below.
62