Operations Value Setting; Operations Related To Flight Conditions - FUTABA R7108SB Full Manual

Common operations used in function setup screen
This section describes the functions often used at the function setup screen. Refer to it when setting
each function.

Operations value setting

Pressing and holding
a value will return it
to its default setting.

Operations related to flight conditions

Group/single mode switching (Gr/Singl)
When setting multiple flight conditions,
linking the setting contents with all conditions
(group mode) or setting independently (single
mode) can be selected. The mode can be
changed at the [Gr] item on each setup screen.
[Group/single mode switching]
Tap
●Group mode (Gr)
The same setting contents are set to all
the flight conditions.
●Single mode (Singl)
Set this mode when the setting contents
are not linked with other conditions.
Tapping the value setting buttons on each screen will cause value input
buttons to appear at the top of the panel.
Value input buttons display
at the top of the panel
Large change
in value
Tap
208
Small change Large change
in value
Condition delay setting
Unnecessary fuselage motion generated when
there are sudden changes in the servo position
and variations in the operating time between
channels can be suppressed by using the
condition delay function of the condition select
function [Condition select].
When the delay function is set at the
switching destination condition, a delay
corresponding to that amount is applied and the
related functions change smoothly.
[Setting method]
1. Switch to the condition you want to set
and tap the delay[ 0 (value)].
2. Set the delay using the " ▼▼ " " ▼ " " ▲ "
"▲▲" buttons
Initial value: 0
Adjustment range: 0~27 (maximum delay)
(When the value is tapped, the delay is reset to the initial
value.)
in value
Tap