Section 4: Operations; Operation Overview - Grizzly G0853 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
The Model G0853 does not ship with a main
blade. Refer to Blade Requirements and
Blade Selection beginning on Page 50 when
purchasing the main blade.
-46-
manual BEFORE
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for cutting.
2.
Adjusts blade tilt, if necessary, to correct
angle of desired cut.
3.
Adjusts blade height approximately
than thickness of workpiece.
4.
Adjusts fence to desired width of cut then
locks it in place.
5.
Adjusts blade guard for workpiece height.
6.
Checks outfeed side of machine for proper
support and to make sure workpiece can
safely pass all the way through the blade
without interference.
7.
Puts on safety glasses, a respirator, and
hearing protection. Locates push sticks, if
needed.
8. Turns dust collection system ON.
9. Turns saw ON.
10. Feeds workpiece all the way through blade
while maintaining firm pressure on workpiece
against table and fence.
11. Turns machine OFF immediately after cut is
complete and waits for blades to completely
stop before removing workpieces.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0853 (Mfd. Since 07/18)
⁄ " higher
1
4