Grizzly G0853 Owner's Manual page 40

53. Slide 3" dust hose over 3" dust port on middle
guard arm and dust port on blade guard,
and secure with (2) 3
Figure 55).
Blade Guard
Figure 55. 3" dust hose installed on middle
guard arm and blade guard.
54. Remove (4) pre-installed M8-1.25 x 25 cap
screws, 8mm lock washers, and 8mm flat
washers from top of middle guard arm post,
and use these to attach upper guard arm (see
Figure 56).
x 4
Figure 56. Upper guard arm installed on middle
guard arm post.
-38-
⁄ " hose clamps (see
1
4
Hose Clamp
(1 of 2)
Middle
Guard Arm
Dust
Hose
Upper
Guard Arm
55. Remove (2) pre-installed M5-.8 x 10 cap
screws and 5mm flat washers from bottom
of upper guard arm and install steel tab (see
Figure 57).
x 2
Figure 57. Steel tab installed on upper guard
arm.
56. Use (4) M5-.8 x 16 cap screws, 5mm lock
washers, and 5mm flat washers to attach
overhead control panel to upper guard arm
(see Figure 58).
Control Panel
Figure 58. Control panel attached to upper
guard arm.
Model G0853 (Mfd. Since 07/18)
Steel Tab
x 4