Grizzly G0853 Owner's Manual page 36

31. Place crosscut fence on crosscut table and
turn fence onto its side.
32. On crosscut fence end nearest blades:
a. Insert (1) M8-1.25 x 35 T-bolt into T-slot,
(see Figure 41).
T-Bolt
Figure 41. Crosscut fence hardware near to
blade.
b. Position crosscut fence so it is close to
but not touching blades.
c. Align T-bolt with pivot hole (see
Figure 41).
Note: Pivot lock knob will help secure
crosscut fence in later step.
33. In middle of crosscut fence:
a. Locate pre-installed M8-1.25 x 35 T-bolt
(see Figure 42).
b. Align T-slot bolt with slot in pre-installed
angle scale bar (see Figure 42).
Note: Angle scale lock knob, T-slot plate,
and 8mm fender washer will help secure
crosscut fence in later step.
-34-
Pivot Lock
Knob
Figure 42. Crosscut fence hardware in middle.
34. On end of crosscut fence farthest from blade.
Pivot
Hole
T-Slot Plate
Angle Scale
Lock Knob
T-Bolt
Ensure latch on 0° stop block is rotated
parallel with crosscut fence, as shown in
Figure 43.
Latch
Stop Bolt
Figure 43. Latch on 0° stop block positioned
parallel with crosscut fence.
Model G0853 (Mfd. Since 07/18)
Washer
Angle
Scale Bar
0° Stop
Block