Grizzly G0853 Owner's Manual page 38

42. Install (1) M12-1.75 x 75 hex bolt and (1)
M12-1.75 hex nut on welded tab, as shown
in Figure 47.
Welded
Tab
Hex Bolt
Figure 47. Fasteners installed on welded tab.
43. Remove (3) pre-installed hex nuts and wash-
ers from M20-2.5 x 130 studs (see Figure 48)
on back side of machine.
44. Install lower guard arm on studs (see
Figure 48), and
nuts and washers
43. Only hand-tighten for now.
Studs
Figure 48. Lower guard arm installed on studs.
-36-
Hex Nut
secure with hex
removed in Step
Lower
Guard Arm
45. Use a level to ensure lower guard arm is par-
allel with the floor.
46. Secure position of lower guard arm by adjust-
ing hex bolt installed in Step 42 until head
of bolt rests against top of guard arm, then
tighten hex nut against tab.
47. Tighten hex nuts installed in Step 44 (see
Figure 49).
Lower
Guard Arm
Figure 49. Tightening hex nuts to secure lower
guard arm.
48. Use (4) M8-1.25 x 25 cap screws, 8mm lock
washers, and 8mm flat washers to attach
middle guard arm post to lower guard arm
(see Figure 50).
Middle Guard
Arm Post
Figure 50. Middle guard arm post attached to
lower guard arm.
Model G0853 (Mfd. Since 07/18)
x 3
x 4