Section 4: Operations - Grizzly T23089 Instruction Manual

section 4: operations

this tool presents serious injury
hazards to untrained users. read
through this
become familiar with the controls
and operations before using the
tool!
eye inJury hazard!
Wear safety goggles with full eye
protection from all sides when
using this grinder.
Wear protective
equipment when
using this tool.
disconnect before
service or tool
changes.
never exceed max
psi rating for tool.
-6
-
entire manual
lung/ear
inJury hazard!
accidental
start hazard!
air pressure
hazard!
using the cut-off saw
read and understand all safety instructions
in this manual before starting.
Always test on a scrap piece of material
similar to the workpiece. trial and error is
often the best way to determine the ideal
setup.
to use the cut-off saw:
to
1. if the workpiece is not completely sta-
ble on its own, make sure it is securely
held in a vise or a similar device that
will ensure it does not move during
operation.
2. Make sure the cut-off wheel is properly
secured by tightening the arbor cap
screw.
never use this tool without the guard
installed. do not modify the guard
in any way. using this tool with a
removed or modified guard greatly
increases the risk of personal injury.
3. Attach the tool to an air supply that is
set at 90 psi.
4. hold the tool securely with both hands,
turn it ON by depressing the trig-
ger, then ease the wheel against the
workpiece with a light but steady pres-
sure.
5. to turn the tool OFF, release the trig-
ger.
note: To avoid accidental startup, dis-
connect the tool from the air supply
when it is not in use.
t23089 (Mfg since 11/10)