Grizzly G0853 Owner's Manual page 34

21. On front of leadscrew housing assembly,
locate center pin on rip fence base mounting
bracket (see Figure 33).
Center Pin
Figure 33. Location of rip fence mounting
bracket.
22. Position rip fence base over center pin on
mounting bracket (see Figure 34) and lower
rip fence base into place. Secure with (2)
M12-1.75 x 30 cap screws and 12mm lock
washers, and install slide lock handle.
x 2
Figure 34. Rip fence base mounted on bracket.
23. Install (1) 16mm plastic cap in center pin hole
and (2) 22mm plastic caps over cap screw
holes.
-32-
Mounting
Bracket
Slide Lock
Handle
Rip Fence
Base
24. Connect rip fence sensor housing wire (see
Figure 35) to matching wire emerging from
rip fence base.
Note: Rip fence sensor housing comes from
the factory pre-wired to the electrical box.
Rip Fence
Base Wire
Figure 35. Rip fence sensor wires attached.
25. Attach rip fence sensor housing (see Figure
36) to rip fence base using (2) pre-installed
M5-.8 x 45 Phillips head screws.
Release
Housing
Figure 36. Rip fence sensor housing attached to
rip fence base.
Model G0853 (Mfd. Since 07/18)
Sensor
Housing Wire
x 2