Grizzly G0853 Owner's Manual page 35

26. Slide rip fence onto clamping plate, as shown
in Figure 37, and secure with slide lock
handle.
Rip
Fence
Figure 37. Rip fence attached to rip fence base.
27. Attach rip fence wiring harness connector
(see Figure 38) to electrical box connector
and lock both latches to secure.
Figure 38. Rip fence wiring harness connector
attached to electrical box connector.
Model G0853 (Mfd. Since 07/18)
Slide Lock
Handle
Electrical Box
Connector
Wiring Harness
Connector
28. With assistance from other people, place
crosscut table on swing arm pivot pin and
place crosscut table mounting plate on sliding
table mounting rod, as shown in Figure 39.
Tighten handle to lock crosscut table against
sliding table.
Crosscut Table
Mounting Plate
Mounting
Rod
Figure 39. Attaching crosscut table to machine
frame.
29. Slide (1) M8-1.25 T-nut into crosscut table
support bar T-slot, and align with hole in
crosscut table (see Figure 40).
30. Secure support bar by threading (1) M8-1.25
x 50 knob bolt and 8mm fender washer into
T-nut (see Figure 40).
Crosscut Table Support Bar
Figure 40. Attaching support bar to crosscut table.
Swing Arm
Pivot Pin
Locking
Handle
-33-